Re: Molding Machine Software
| Newsgroups | gmane.comp.systems.as400.mapics |
|---|---|
| Message-ID | <OFDB4191F4.BA3E73E3-ON8625773E.0065066B-8625773E.00656127@epcmolding.com> |
Hello, We use ProHelp EPM. I run a daily job on the 400 to update (FTP) BOM, Routing changes, and new Items to ProHelp. It's been running since 2003. We are at V4R5 of the OS and XAR6 of MAPICS. Thanx, Nick Nick Radich Sr. Programmer/Analyst EPC Molding, Inc. Direct (320) 679-6683 Toll free (800) 388-2155 ext. 6683 Fax (320) 679-4516 [email protected] From: [email protected] To: mapics-l-Zwy7GipZuJhWk0Htik3J/[email protected] Date: 06/10/2010 12:47 PM Subject: [MAPICS-L] Molding Machine Software Sent by: mapics-l-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] I am curious to know what are folks using to monitor injection molding machines, along the lines of Mattec ProHelp EPM or Plantstar? _______________________________________________ This is the MAPICS ERP System Discussion (MAPICS-L) mailing list To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mapics-l or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mapics-l. _______________________________________________ This is the MAPICS ERP System Discussion (MAPICS-L) mailing list To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mapics-l or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mapics-l.