Re: Ending PowerLink session before nightly save.

Hello,

I thiink this wil do the trick.
It is pretty old and have changed it a litle bit.
But it runs every night.



Met vriendelijke groet
Yours sincerely
Bien à vous
JWB Software
Jules Bloemsaat
iSeries software consultant
[email protected]
http://jwbsoftware.nl
Telefoon +31 (0)6 16 377 002
Kvk nr 18086239


2010/11/10 Weston Wheat <[email protected]>

> Good morning all.
>
> Does anyone know of a Mapics command or have a small program that will
> end all Powerlink sessions
>
> before a Mapics nightly save. I would run it as a Pre-Backup command  in
> the save options.
>
>
>
> Thanks
>
> Weston
>
>
>
>
>
>
>
>
> _______________________________________________
> This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
> To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected]
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/mapics-l
> or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/mapics-l.
>
>
>

_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.