Re: New ISeries - Old Twinax

We also use  an e-twinax 3 device controller to support 2 old twinax devices on our Power6. Configuration is via http web interface. The device converts any twinax device so the iSeries sees it as  native IP. It comes with software that keeps the twinax devices up and running,  no need to vary devices off and back on if there's an error. It's been very reliable -  "Set it and forget it."
This electronic message transmission is intended only for the use of the party to which it is addressed, including any attachments and contains information from AeroControlex Group Inc., which may be privileged, confidential, or protected by law. If you are not the intended recipient you are hereby notified that any dissemination, copying or distribution of this e-mail or its contents is strictly prohibited. If you have received this message in error, please notify us immediately by replying to the message and deleting it from your computer. Thank you. ITAR Notice: This email may contain technical data which may be controlled by the US International Traffic in Arms Regulation (ITAR) 22 CFR part 120-130. If this data is determined to be ITAR controlled, such data may not be transmitted, sha
 red or provided to any foreign party or entity either verbally or visually without proper licenses from the State Department. It is your responsibility to assure this item can be legally sh!
 ared with another party.
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.