Raw material loss amount on IP transaction

Any ideas on how to handle material loss on a IP transaction to account for material loss during sawing operations, etc.  For example MO calls for 20" of steel, material is cut to 20" but 1/8" is lost for each cut.  Need to issue the 1/8" to keep inventory accurate.


Tim Rutz | Senior Systems Programmer / Analyst
Douglas Machine Inc. | Tel: 320.762.6348
douglas-machine.com<http://www.douglas-machine.com/> | [email protected]

EMPLOYEE OWNED, CUSTOMER DRIVEN.

The information transmitted in this e-mail is intended only for the person or entity to which it is addressed and contains confidential and/or privileged material. This material may further be covered under a separate nondisclosure agreement. Any review, re-transmission, dissemination or other use of, or pursuing of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. If you have received this communication in error, please first notify the sender immediately and then delete this communication from all data storage devices and destroy all hard copies. Please consider the environment before printing this email.
-- 
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: [email protected]
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request-+hD5IHI5Xscn3HwCXmMcX9BPR1lH4CV8@public.gmane.org
Before posting, please take a moment to review the archives
at https://archive.midrange.com/mapics-l.