Re: Support for S/36 mode
[email protected] Fri, 10 Sep 2004 07:22:32 -0500
| Newsgroups | gmane.comp.systems.as400.open-source |
|---|---|
| Message-ID | <OF1F0FF567.B92DC420-ON05256F0B.0043ED46-05256F0B.0043E199@dekko-1> |
I've not heard anything like that. Now they did stop the *M36 support, but that was a few releases back. Rob Berendt -- Group Dekko Services, LLC Dept 01.073 PO Box 2000 Dock 108 6928N 400E Kendallville, IN 46755 http://www.dekko.com "Wilbert van der Hoeven" <[email protected]> Sent by: oss400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] 09/10/2004 06:50 AM Please respond to Open Source Software for the AS400/iSeries <oss400-Zwy7GipZuJhWk0Htik3J/[email protected]> To <oss400-Zwy7GipZuJhWk0Htik3J/[email protected]> cc Fax to Subject [OSS400] Support for S/36 mode Hi all, Does it anybody know whether or when IBM is going to stop support for S/36 mode on the iSeries? Regards, Wilbert _______________________________________________ This is the Open Source Software for the AS400/iSeries (OSS400) mailing list To post a message email: OSS400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/oss400 or email: OSS400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/oss400. _______________________________________________ This is the Open Source Software for the AS400/iSeries (OSS400) mailing list To post a message email: OSS400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/oss400 or email: OSS400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/oss400.