Re: What is the best way to allow this to work?

On 28/08/2008, at 6:50 AM, Steve McKay wrote:

> I have a user who have no *SPCAUT.  She is trying to run a utility  
> program
> which allocates physical file members.  It runs the following command:
>
> OVRDBF FILE(MBRNAM) FRCRATIO(1) WAITFILE(*IMMED) WAITRCD(*IMMED)  
> SHARE(*NO)
> OVRSCOPE(*CALLLVL)
>
> When the user runs it, she gets a CPF1337 - Cause . . . . . :   &3/ 
> &2/&1 is
> not authorized to change either parameters Run priority, Time  
> slice, Purge,
> Time slice end pool, or Default wait time.  Special job control  
> authority is
> required to change the requested parameter(s).  (I suppose that  
> this is due
> to the WAITFILE or the WAITRCD parm.)

I'm fairly certain that message is NOT sent by OVRDBF. CHGJOB sends  
that message. Re-examine the job log and show the from and to program  
information for the message.

Regards,
Simon Coulter.
--------------------------------------------------------------------
    FlyByNight Software         OS/400, i5/OS Technical Specialists

    http://www.flybynight.com.au/
    Phone: +61 2 6657 8251   Mobile: +61 0411 091 400        /"\
    Fax:   +61 2 6657 8251                                   \ /
                                                              X
                  ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------



_______________________________________________
This is the Security Administration on the AS400 / iSeries (Security400) mailing list
To post a message email: Security400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/security400
or email: Security400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/security400.