Re: Restrict tcp/ip function in one adapter

I'm guessing, but probably using the Packet Rules editor in iSeries
Navigator.  In Nav, select (system) - Network - IP Policies - Packet Rules.
Right-click Packet Rules and select the editor.

On Wed, Jul 22, 2009 at 11:16 AM, <gbrause2000-/[email protected]> wrote:

>
> If I have 2 eth. adapters, how do I chose the tcp/ip services that run on
> each one?
> I like only ftp and telnet in one and everything in the other.
>
> Tks,
> g
>
>
>
>
> _______________________________________________
> This is the Security Administration on the AS400 / iSeries (Security400)
> mailing list
> To post a message email: Security400-Zwy7GipZuJhWk0Htik3J/[email protected]
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/security400
> or email: Security400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/security400.
>
>


-- 
JJ
"I'm in no condition to drive...Wait! I shouldn't listen to myself, I'm
drunk!"
 - Homer J. Simpson
_______________________________________________
This is the Security Administration on the AS400 / iSeries (Security400) mailing list
To post a message email: Security400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/security400
or email: Security400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/security400.