SSL for CA

Not sure where to post this, so I will start here.  Please move if in 
wrong list.

I have setup SSL on V5R4 (at least I think I have), but when I issue the 
strtcpsvr(*telnet) command it reports back it is already started - which 
is true for port 23, but I do not see it started for port 992.  I'm using 
the netstat *cnn command to look.

Is there somewhere I can look to see why it isnt starting?  Displaying the 
job doesn't show any errors.  I was hoping I didn't have to drop telnet & 
bring it back up :(

Steve Jones
_______________________________________________
This is the Security Administration on the AS400 / iSeries (Security400) mailing list
To post a message email: Security400-Zwy7GipZuJhWk0Htik3J/[email protected]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/security400
or email: Security400-request-Zwy7GipZuJhWk0Htik3J/[email protected]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/security400.