Re: [PATCH] Fix spurious testsuite failure when /bin/sh is dash

On 12/17/2014 02:18 PM, Stefano Lattarini wrote:
> The testsuite used slightly different logic in the code employed to
> decide whether a test should be skipped due to a limitation of the
> selected shell, and in the code running the test itself.
>
> * tests/autotest.at (Syntax error): Adjust.
> (parallel syntax error): Likewise.
>
> Signed-off-by: Stefano Lattarini <[email protected]>
> ---
>   tests/autotest.at | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/tests/autotest.at b/tests/autotest.at
> index a985f86..8182c83 100644
> --- a/tests/autotest.at
> +++ b/tests/autotest.at
> @@ -397,7 +397,7 @@ AT_CHECK_AT_TEST([Syntax error],
>      AT_CHECK([${CONFIG_SHELL-$SHELL} -c 'case `. ./syntax; echo $?` in
>   		  0|"") exit 77;;
>   		esac'], [0], [ignore], [ignore])
> -   AT_CHECK([$CONFIG_SHELL ./micro-suite], [1], [ignore], [stderr])
> +   AT_CHECK([${CONFIG_SHELL-$SHELL} ./micro-suite], [1], [ignore], [stderr])
>      AT_CHECK([grep "unable to parse test group: 2" stderr], [0], [ignore])],
>     [1 3])
>
> @@ -1507,7 +1507,7 @@ AT_CHECK_AT_TEST([parallel syntax error],
>      AT_CHECK([${CONFIG_SHELL-$SHELL} -c 'case `. ./syntax; echo $?` in
>   		  0|"") exit 77;;
>   		esac'], [0], [ignore], [ignore])
> -   AT_CHECK([$CONFIG_SHELL ./micro-suite -j], [1], [ignore], [stderr])
> +   AT_CHECK([${CONFIG_SHELL-$SHELL} ./micro-suite -j], [1], [ignore], [stderr])
>      AT_CHECK([grep "unable to parse test group: 2" stderr], [0], [ignore])],
>     [-j2 1 3])
>
>
Will push in a couple of days if nobody objects.

Regards,
   Stefano