Re: [PATCH] automake: avoid harmful directory change before invoking valac

On Fri, 2014-12-19 at 22:01 +0100, Stefano Lattarini wrote:
> Hi, thanks for the patch, and sorry for the delay.
> 
> On 12/02/2014 02:22 PM, Yanko Kaneti wrote:
> > The current am__cd right before invoking valac invalidates
> > any relative flags setup done before that.
> > 
> > https://bugzilla.gnome.org/show_bug.cgi?id=740825
>  >
> BTW, this was already reported as http://debbugs.gnu.org/13002 So 
> finally fixing it would likely be a good idea.
> 
> > ---
> >   bin/automake.in | 3 ++-
> >   1 file changed, 2 insertions(+), 1 deletion(-)
> > 
> Such a fix requires at least a new test case and a NEWS entry. Care 
> to take at stab at writing them?

Sorry,
I looked a bit in the t/ directory but my eyes glazed over.
Perhaps I am not the best person to attempt those.

> > diff --git a/bin/automake.in b/bin/automake.in
> > index 4cee0d0..3082207 100644
> > --- a/bin/automake.in
> > +++ b/bin/automake.in
> > @@ -5476,6 +5476,7 @@ sub lang_vala_finish_target
> >     my $silent = silent_flag ();
> >     my $stampfile = "\$(srcdir)/${derived}_vala.stamp";
> > 
> > +  map { !/^\// && ($_ = "\$(srcdir)\/" . $_) } @vala_sources;
>  >
> What is the point of the "!/^\//" conditional?

The idea was to protect from mangling any vala_sources that might 
already be absolute paths. If that's not expected or supported then it 
can be dropped.

> >       "\$(srcdir)/${derived}_vala.stamp: @vala_sources\n".
> >   # Since the C files generated from the vala sources depend on the
> > @@ -5485,7 +5486,7 @@ sub lang_vala_finish_target
> >   # Thus we need to create the stamp file *before* invoking valac, 
> > and to
> >   # move it to its final location only after valac has been 
> > invoked.
> >       "\t${silent}rm -f \$\@ && echo stamp > \$\@-t\n".
> > -    "\t${verbose}\$(am__cd) \$(srcdir) && $compile 
> > @vala_sources\n".
> > +    "\t${verbose}$compile -d \$(srcdir) @vala_sources\n".
> >       "\t${silent}mv -f \$\@-t \$\@\n";
> > 
> >     push_dist_common ($stampfile);
> > 
> 
> Thanks,
>    Stefano

Regards and sorry for the dalay
Yanko