Re: BackupPC 4.1.0 released

I'm not sure how you are using configure.pl to build a package.

In any case, what I meant was you should try adding --config-path '' to the
existing configure.pl arguments.  Is that enough to have it ignore any
existing installation?w

Craig

On Sat, Mar 25, 2017 at 7:15 PM, Richard Shaw <[email protected]> wrote:

> On Sat, Mar 25, 2017 at 8:18 PM, Craig Barratt <
> [email protected]> wrote:
>
>> Do you mean an option to configure.pl to ignore an existing install?
>>
>> Have you tried doing this:
>>
>> ./configure.pl --config-path ''
>>
>> (that's 2 single quotes to create an empty --config-path).  It should
>> prompt for the config.pl path, and just hit enter.
>>
>
> Hmm... That would be a nogo since package building can't be interactive...
>
> Thanks,
> Richard
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> BackupPC-devel mailing list
> [email protected]
> List:    https://lists.sourceforge.net/lists/listinfo/backuppc-devel
> Wiki:    http://backuppc.wiki.sourceforge.net
> Project: http://backuppc.sourceforge.net/
>
>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
BackupPC-devel mailing list
[email protected]
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-devel
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/