Re: Troubleshoot full pool for 4.0 worth it?
Bill Broadley <[email protected]> Tue, 4 Apr 2017 22:19:42 -0700
| Newsgroups | gmane.comp.sysutils.backup.backuppc.devel |
|---|---|
| Message-ID | <[email protected]> |
On 04/04/2017 10:16 PM, Craig Barratt wrote:
> Bill,
>
> What is $Conf{PoolV3Enabled} set to?
root@node1:/etc/backuppc# cat config.pl | grep PoolV3
$Conf{PoolV3Enabled} = '0';
I did that after the V3 to V4 migrate completed. I ran the migrate again and it
didn't do anything and finished quickly. I restarted the backuppc daemon as well.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
BackupPC-devel mailing list
[email protected]
List: https://lists.sourceforge.net/lists/listinfo/backuppc-devel
Wiki: http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/