Re: Disabling encryption for internal network

Are you sure that SSH encryption is actually slowing down the backup?  I
wouldn't think so, as most devices have AES in hardware and SSH is pretty
efficient.  Before you just bypass it, I would test to see if that's
actually the bottleneck.

You could just run raw rdiff vs rdiff-over-ssh to test.  I suspect the
local I/O is the bottleneck and not encryption or network speed.

-derek

On Fri, April 3, 2020 12:18 pm, Dark Empathy wrote:
> Hi,
>
> Please excuse the simple question, but I am unable to work out what to do
> from the man page alone.
>
> What is a way to disable encryption for an internal network, where it is
> not required? (Linux to Linux).  Is this possible with perhaps a rsync
> server and --remote-schema?
>
> I have a situation where we have data on Raspberry Pi 3's. spread over a
> private WAN.  Data security, in this particular case, is of zero
> importance.  However, I would prefer not to disable encryption on the SSH
> server.
>
> Are there any suggestions to run rdiff-backup at maximum speed, no
> encryption, on an internal network?
>
> Thankyou kindly.
>


-- 
       Derek Atkins                 617-623-3745
       [email protected]             www.ihtfp.com
       Computer and Internet Security Consultant