Re: Help with configuration needed for menu using PicoLCD driver

> Try changing the debug reporting level fromRPT_DEBUG to RPT_NOTICE in 
> function picoLCD_get_key in file server/drivers/picolcd.c and 
> rebuilding with debug enabled.
> ./configure --enable-drivers=picolcd  --enable-debug  --enable-lcdproc-menus
> make
> Then run the server with debug reporting and see what is reported when 
> you press a key.
> ./server/LCDd -fr3 -c ./LCDd.conf
> The key definitions from my configuration file are as below, much as 
> Markus suggested.
> # The "...Key=" lines define what the server does with keypresses that
> # don't go to any client. The ToggleRotateKey stops rotation of screens, while
> # the PrevScreenKey and NextScreenKey go back / forward one screen (even if
> # rotation is disabled.
> # Assign the key string returned by the driver to the ...Key setting. These
> # are the defaults:
> ToggleRotateKey=Enter
> PrevScreenKey=Left
> NextScreenKey=Right
> ScrollUpKey=Up
> ScrollDownKey=Down
>
> ## The menu section. The menu is an internal LCDproc client. ##
> [menu]
> # You can configure what keys the menu should use. Note that the MenuKey
> # will be reserved exclusively, the others work in shared mode.
>
> # Up to six keys are supported. The MenuKey (to enter and exit the menu), the
> # EnterKey (to select values) and at least one movement keys are required.
> # These are the default key assignments:
> #MenuKey=Escape
> MenuKey=F5
> EnterKey=Enter
> UpKey=Up
> DownKey=Down
> LeftKey=Left
> RightKey=Right
> Regards,
>
> Martin
>

Many thanks for the response and sorry for such a looooong delay!!! 
Things got kinda hectic for a while.


I have actually got the F1 key to start the menu so that's not an issue :-)


I was just wondering however, if I wanted to use the +/- keys what would 
they be called as I'm guessing the **Enter** key is the **OK** key in 
the center of the keypad?


So also quick question, how to re-enable rotation?


If I press **Enter** the rotation stops then how to do the reverse?


Thanks,


Kaya

_______________________________________________
LCDproc mailing list
[email protected]
http://lists.omnipotent.net/mailman/listinfo/lcdproc