Re: CFontz 634 serial & OpenBSD 5 not working

Ok I got it running!! Thanks Markus, the problem was the device /dev/tty00.
Just configured LCDd.conf with /dev/cua00 and it works fine!.

Thank you all, now i can check my server's status without logging in.

by the way, how can i compile LCDd with hbars support?
i tried ./configure --enable-driver=CFontz --enable-seamless-hbars=yes
no errors but when executing LCDd it says that hbars are not supported

El 24 de febrero de 2012 11:15, Edd Barrett <[email protected]> escribió:

> On Fri, Feb 24, 2012 at 09:16:23AM +0100, Alejandro Pose wrote:
> >  Hi again
> >
> >  I really searched for this port and didn't find it, neither under comms
> >  or sysutils:
>
> It wasn't in OpenBSD-5.0, it is in -current and will be in OpenBSD-5.1:
> http://www.openbsd.org/cgi-bin/cvsweb/ports/comms/lcdproc/
>
> >
> >  root@kalima:[/usr/ports]# find . -name lcd*
> >  root@kalima:[/usr/ports]#
>
> ^ BTW
>
> `make search name=lcd` is quicker than find ;)
>
> --
> Best Regards
> Edd Barrett
>
> http://www.theunixzoo.co.uk
>

_______________________________________________
LCDproc mailing list
[email protected]
http://lists.omnipotent.net/mailman/listinfo/lcdproc