Re: Compiling on OpenBSD RELEASE 5.0 x64

On 12.03.2012 21:24, Kaya Saman wrote:
> 
> I first attempted a standard Install run by doing:
> 
> ./configure
> make
> make install
> 
> which worked fine until I restarted the system then tried to re-run
> LCDd....
> 
> this didn't go so well as it claimed the the curses.so driver wasn't
> installed?
> 
> 
> I then tried again with:
> 
> make clean
> ./configure --enable-driver=curses
> gmake
> gmake install
> 
> 
> whose output came to this:
> 
> # LCDd
> Could not open driver module server/drivers/curses.so: File not found
> Driver [curses] binding failed
> Could not load driver curses
> There is no output driver
> Critical error while initializing, abort.
> # /usr/local/sbin/LCDd
> Could not open driver module server/drivers/curses.so: File not found
> Driver [curses] binding failed
> Could not load driver curses
> There is no output driver
> Critical error while initializing, abort.
> 
> 
> What's really interesting is that if recompiled it runs fine, but if
> stop/started it doesn't run????
> 
> 
> Regards,
> 
> 
> Kaya
> 

Hi,

please verify that:

a) You are using the correct LCDd.conf.
b) The 'DriverPath' option in LCDd.conf is set correctly.

The line 'Could not open driver module server/drivers/curses.so: File
not found' indicated the DriverPath option is not set correctly to the
path where the driver files got installed.

Regards,
Markus