Re: Syslog the 'enable command'

No,
Only thing you get is when someone exits out of enabled mode.
 

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf
Of Ron Widlewski
Sent: Monday, November 06, 2006 9:08 AM
To: [email protected]
Subject: [logs] Syslog the 'enable command'

Is there a procedure to (unix) syslog the use of the Cisco "enable"
command when used on any Cisco device ?





************************************************************************
****
Confidentiality Notice: 
This e-mail message, any attachment, and the information therein is
confidential, intended only for the named recipient(s), and may contain
material that is proprietary, privileged, or otherwise private under
applicable law.  If you have received this message in error, or are not
a named recipient: 
 
(1) You are advised that any disclosure, copying, distribution or use of
this e-mail, or the information in its content, is strictly prohibited;
(2) We ask you immediately to notify the sender by return e-mail or
contact Third Federal at 1-888-THIRD-FED (1-888.844-7333);
(3) We instruct you to delete this e-mail message and any attachment
from your computer.  

Thank you.
************************************************************************
****

_______________________________________________
LogAnalysis mailing list
[email protected]
http://lists.shmoo.com/mailman/listinfo/loganalysis