RE: Agent Builder V6.2.3 and SNMP version

Hey Anders, I did the same thing with a SNMP agent for "gets" but my agent builder wasn't at FP01.  I can't seem to get the customer to configure the Integrated Management Module (IMM) for v3.  The first thing I would check is if you could do a SNMP get on a particular OID.   Regards,



Gregory R. Mendes
770-317-8593

 From: Anders.Soderback-9m31T990Z1pWk0Htik3J/[email protected]
To: [email protected]
Date: Tue, 29 Jan 2013 14:54:08 +0000
CC: 
Subject: [TME10] Agent Builder V6.2.3 and SNMP version

I am developing an agent with Agent Builder V6.2.3 FP1 to retrieve data with ‘SNMP get’ using the SNMPv2 connection type. The target was configured to support SNMPv2 , but no data was retrieved. The target had to be configured to support SNMPv1 as well. Regardless of what the configuration was set to on the Agent Builder agent, whether it was SNMPv1, v2c or v3 the agent always connected with SNMPv1. This could be seen capturing the network packet.  Has anyone come across this issue? Is there a fix? Regards,Anders Anders Soderback 
Senior Consultant Email: anders.soderback-9m31T990Z1pWk0Htik3J/[email protected] 
Twitter: @OrbData 
Switchboard: +44 (0) 1628 550450 
Address: The Chapel, Grenville Court, Britwell Road, Burnham, SL1 8DF, United Kingdom AAA Accredited IBM 
Business Partner Self-service for 
Tivoli Monitoring Orb Data Limited, registered in England No. 03429749 
Registered Office, 29 Devizes Road, Swindon, Wiltshire, SN1 4BG, United Kingdom  
______________________________________________________________________

This email has been scanned by the Symantec Email Security.cloud service.

For more information please visit http://www.symanteccloud.com

______________________________________________________________________


_______________________________________________
TME10 mailing list
[email protected]
Unsubscribe:[email protected]

_______________________________________________
TME10 mailing list
[email protected]
Unsubscribe:[email protected]