Re: Agent Builder V6.2.3 and SNMP version

Are you doing SubNodes with your SNMP Agentbuilder agent ?

I created one with no Sub Nodes doing SNMP v3 GETS against our BigIP
F5 and its working ok.

Doan

On 1/29/13, Allen Lutz <[email protected]> wrote:
> How does one get nominated for the beta?
>
> On Tue, Jan 29, 2013 at 10:28 AM, Julius Loman <[email protected]> wrote:
>
>> On Tue, Jan 29, 2013 at 02:54:08PM +0000, Anders Soderback <
>> Anders.Soderback-9m31T990Z1pWk0Htik3J/[email protected]> wrote:
>> > I am developing an agent with Agent Builder V6.2.3 FP1 to retrieve data
>> with
>> > 'SNMP get' using the SNMPv2 connection type. The target was configured
>> > to
>> > support SNMPv2 , but no data was retrieved. The target had to be
>> configured
>> > to support SNMPv1 as well. Regardless of what the configuration was set
>> to on
>> > the Agent Builder agent, whether it was SNMPv1, v2c or v3 the agent
>> always
>> > connected with SNMPv1. This could be seen capturing the network packet.
>> >
>> > Has anyone come across this issue? Is there a fix?
>> My colleague mentioned something similar - agent in agent builder always
>> retrieved data using snmpv1 (he needed snmpv3). However agent built and
>> installed worked well, so it's probably only an issue with agent testing
>> feature.
>>
>> If you have access to 6.3 beta, try using the 6.3 agentbuilder. It allows
>> you
>> to test whole agent, not only particular attribute group. I guess this
>> issue
>> might be fixed in that version.
>>
>>
>> --
>>
>> [ Julius Loman ][ [email protected] ][ http://lomo.kyberia.net ][
>> icq:35732873 ]
>>
>>
>> _______________________________________________
>> TME10 mailing list
>> [email protected]
>> Unsubscribe:[email protected]
>>
>>
>
>
> --
> [email protected]
> 845-546-1139
>


-- 
Regards

Doan Nguyen

_______________________________________________
TME10 mailing list
[email protected]
Unsubscribe:[email protected]