RE: FTO Standby TEMS high cpu during sync

Hi John. Yes I just did a cleardeploystatus because that was the only indication in the logs of anything strange. Something that would not sync. Error gone after command.
But it didn’t help much. I’m thinking LFA pure events they used to fill up a table so kdsmain ran out of memory eventually.
Is this table synced?

/Gus



From: [email protected] [mailto:[email protected]] On Behalf Of John Alvord
Sent: den 1 februari 2013 17:30
To: Discussion list for Tivoli product and Tivoli Ready products.
Subject: Re: [TME10] FTO Standby TEMS high cpu during sync

Normal. The logic has to cross check a lot of objects, that means lots of SQLs and SQLs really chew up the CPU. Usually the two hub TEMS are close in the network and so lots of SQLs plus no waiting means very high CPU.

I did run into a case recently where a customer had not done a

tacmd cleardeploystatus -a

for a couple years - and the high CPU lasted for about 10 hours!!

So don't forget that aspect of the environment.

Regards,




John Alvord - Ph: 1-720-396-2788    Cell: none
Customer Support - Tivoli Software - jalvord-r/[email protected]<mailto:[email protected]>
Advisory Engineer - Tivoli Monitoring - ITM infrastructure
Follow us on Twitter! @Tivolisupport<http://twitter.com/TivoliSupport> and Facebook<https://www.facebook.com/IBMTivoliSupport>
Personalize your support needs with the IBM Support Portal<http://www.ibm.com/support/electronicsupport/>
Use Service Request<http://www.ibm.com/software/support/servicerequest/quick_start.html> to get assistance!
For emails regarding a PMR, copy [email protected]<mailto:[email protected]>
For secure browser uploads: https://www.ecurep.ibm.com/app/upload
For Customer Support guidance: IBM Software Support Handbook<http://www14.software.ibm.com/webapp/set2/sas/f/handbook/home.html>









From:        <[email protected]<mailto:[email protected]>>
To:        <[email protected]<mailto:[email protected]>>,
Date:        02/01/2013 07:41 AM
Subject:        [TME10] FTO Standby TEMS high cpu during sync
Sent by:        [email protected]<mailto:[email protected]>
________________________________



Hi.

Everytime between

(510BDF05.0000-10:kdyctrl.cpp,3932,"rTEMSSynchThread") TEMS is MIRROR, Synchronizing with HUB TEMS tables.
And:
q(510BE00D.0000-10:kdyctrl.cpp,4045,"rTEMSSynchThread") Sychronization complete. Going to sleep.

The cpu peaks at 99% an nothing unusual in the *_ms_* logs. HUB on Linux RHEL6 6.2.3 FP02.
As soon as sync is complete it drops to close to nothing within seconds.

I need tips on tracing FTP sync, anyone?

/Gus

 _______________________________________________
TME10 mailing list
[email protected]<mailto:[email protected]>
Unsubscribe:[email protected]

_______________________________________________
TME10 mailing list
[email protected]
Unsubscribe:[email protected]