Re: ITM - Standby HUB on different OS ?
John Alvord <jalvord-r/[email protected]>
| Newsgroups | gmane.comp.sysutils.tivoli.general |
|---|---|
| Message-ID | <OFD4F5BD8B.0915DDAB-ON88257BBA.005A2E84-88257BBA.005A5C8C__45124.1342853338$1375374451$gmane$org@us.ibm.com> |
You can use the Hot Backup setup to go from z/OS to Linux for a one-time conversion where the original hub TEMS is unaware of what is happening. It is the second backup solution here: Sitworld: Best Practice TEMS Database Backup and Recovery https://www.ibm.com/developerworks/community/blogs/jalvord/entry/sitworld_best_practice_tems_database_backup_and_recovery?lang=en Regards, ______________________________________________ John Alvord Advisory Engineer IBM Tivoli Monitoring 6 Platform Customer Support Office: 1-720-396-2788 Mobile: none jalvord-r/[email protected] Cloud & Smarter Infrastructure IBM Support Portal Open a New Service Request Update your PMR via Email Escalate your PMR My Blog: Wonderful World of Situations Secure upload to ECUREP From: Dave Mcneilly/Markham/IBM <[email protected]> To: "Discussion list for Tivoli product and Tivoli Ready products." <[email protected]>, Date: 08/01/2013 09:14 AM Subject: Re: [TME10] ITM - Standby HUB on different OS ? Sent by: [email protected] I just went through this going from windows to zlinux and all is good so far. ----------------- Sent from my BlackBerry Handheld. From: John Alvord [jalvord-r/[email protected]] Sent: 08/01/2013 09:08 AM MST To: "Discussion list for Tivoli product and Tivoli Ready products." <[email protected]> Subject: Re: [TME10] ITM - Standby HUB on different OS ? Among the distributed platforms [WIndows/Linux/Unix] it works fine and QA tests it. The two FTO hub TEMS should be at the same maintenance level. Regards, ______________________________________________ John Alvord Advisory Engineer IBM Tivoli Monitoring 6 Platform Customer Support Office: 1-720-396-2788 Mobile: none jalvord-r/[email protected] Cloud & Smarter Infrastructure IBM Support Portal Open a New Service Request Update your PMR via Email Escalate your PMR My Blog: Wonderful World of Situations Secure upload to ECUREP From: doan nguyen <[email protected]> To: "Discussion list for Tivoli product and Tivoli Ready products." <[email protected]>, Date: 08/01/2013 09:00 AM Subject: [TME10] ITM - Standby HUB on different OS ? Sent by: [email protected] Not ideal, but we are looking into moving to a different OS for our TEMS HUB and Standby. So the first step is to build the new Standby on a different OS and connect this with the old HUB. Is having 2 different OS for the HUB and Standby supported ? and if so any gotcha's ? -- Regards Doan Nguyen _______________________________________________ TME10 mailing list [email protected] Unsubscribe:[email protected] _______________________________________________ TME10 mailing list [email protected] Unsubscribe:[email protected] _______________________________________________ TME10 mailing list [email protected] Unsubscribe:[email protected] _______________________________________________ TME10 mailing list [email protected] Unsubscribe:[email protected]