Re: Partial page print

Hi All,

Avantfax web session keeps logout after short period of time.  How can 
increase the web session time out for avantfax?

Thanks

On 12/08/2015 02:39 PM, Lee Howard wrote:
> On 12/08/2015 01:43 PM, Christo Labuschagne wrote:
>> Thanks for the feedback.  A colleague proposed I maybe try downing 
>> the DTE-DCE speed (previously set at 115200, now at 57k).  For now I 
>> have not seen the issue yet. If it pops up, I will try and change 
>> from 1.0 to 1.  I'm not using a VM but using an embedded environment.
>>
>> Does seem like a serial comms issue though.
>
> Yes, it does.  If you don't see problems at 57600 bps but you do at 
> 115200 bps, then it's almost certainly some kind of flow-control problem.
>
> If leaving it at 57600 bps resolves the matter even for fax images 
> with very, very large amounts of data on them, then I think that is a 
> fine workaround.  However, if you can determine that it will work fine 
> with 115200 bps when ModemFlowControl is set to "xonxoff" instead of 
> "rtscts" (or vice-versa) then it would be best to correctly configure 
> that - EVEN if you then go back to 57600 bps. You really do want to 
> make sure that the flow control is being used properly.
>
> (There will eventually be some page with enough data on it that will 
> overflow the buffer at any bitrate in certain sessions. Proper flow 
> control is important.)
>
> Thanks,
>
> Lee.
>
>
> ____________________ HylaFAX(tm) Users Mailing List 
> _______________________
>  To subscribe/unsubscribe, click 
> http://lists.hylafax.org/cgi-bin/lsg2.cgi
> On UNIX: mail -s unsubscribe [email protected] < 
> /dev/null
>  *To learn about commercial HylaFAX(tm) support, mail [email protected].*
>


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe [email protected] < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail [email protected].*