Re: Can't set AT+FCC and AT+FAP on MultiTech ZBA MT9234ZBA-USB

On 03/30/2016 02:07 AM, Luca wrote:
> Mar 29 18:17:00.01: [31592]: <-- [26:AT+FCC=1,5,2,2,15,1,0,0,0\r]
> Mar 29 18:17:00.03: [31592]: --> [5:ERROR]
> Mar 29 18:17:00.03: [31592]: MODEM Command error
> Mar 29 18:17:00.03: [31592]: DIAL xxxxxxxxxxx
> [...]
>
> Using minicom, the command "AT+FCC=?" prints:
>
> (00-01),(00-05),(00-02),(00-02),(00-01,03-05,07-09,0B-0D,0F),(00-01),(00),(00-07),(00-7F)

And that should be your clue that your config file is wrong.  "15" is 
not permitted.  "F" should be used, instead.  Thus, you should be using:

Class2UseHex: yes

That said, you should probably be basing your config file off of 
config/lucent-mt-20, anyway, rather than building it from scratch, that 
is, if you want to use Class 2.0.

> 1) How should I set "Class2DCCQueryCmd" to work with this modem?

Follow config/lucent-mt-20.

> 2) Should I set "Class2APCmd: AT" like suggested here
> http://www.hylafax.org/archive/2000-11/msg00151.php to avoid the first
> error?

No.  That suggestion was made so that the +FAP command wasn't used at 
all.  You should follow config/lucent-mt-20 or use Class 1.0.

Thanks,

Lee.


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe [email protected] < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail [email protected].*