Re: can I map a "number" for an unregistered endpoint?

Hi Bo!

I think there is some misunderstanding: the "aaa@bbb" and "bbb##aaa" 
notations are the same thing, implemented by different vendors.

For example: to call "aaa" on "bbb" from Cisco codec, I should use 
"aaa@bbb" form and to call the same device on the same gatekeeper I'm 
using "bbb##aaa" form for Sony codecs.

If you want I can attach my configuration.

Kind regards, Sergey.

Tune-IT Logo
www.tune-it.ru
tel: +7(812)3254440
[email protected]
12.09.2016 23:33, Bo Xu пишет:
> Hi Jan,
>
> I can call a permanent-Alias with the following "@" command:
> permanent-Alias@GnuGKIP
>
> also I can call a register-Alias(a terminal who registered to my 
> GnuGK) with the following "##" command:
> GnuGKIP##registered-Alias
>
> but I cannot call permanent-Alias with the above "##" command,  cold 
> you tell me how I can call a permanent-Alias with "##" like 
> "GnuGKIP##permanent-Alias"? Thanks!
>
>
> Regards,
> Bo
>
>
>
> On Wed, Aug 31, 2016 at 1:25 PM, Bo Xu <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     Hi Jan,
>
>     yes I added "[RasSrv::PermanentEndpoints]" you mentioned into my
>     gatekeeper.ini and it works fine now, Thanks a lot!
>
>     Regards,
>     Bo
>
>
>
>
>
>     Hi Bo,
>
>     GnuGk calls those endpoints that don't actively register "permanent
>     endpoints":
>
>     [RasSrv::PermanentEndpoints]
>     10.1.11.116=8000
>
>     Regards,
>     Jan
>
>     -- 
>     Jan Willamowius, Founder of the GNU Gatekeeper Project
>     EMail  : jan@...
>     Website:http://www.gnugk.org <http://www.gnugk.org/>
>     Support:http://www.willamowius.com/gnugk-support.html
>     <http://www.willamowius.com/gnugk-support.html>
>
>     Relaxed Communications GmbH
>     Frahmredder 91
>     22393 Hamburg
>     Geschäftsführer: Jan Willamowius
>     HRB 125261 (Amtsgericht Hamburg)
>     USt-IdNr: DE286003584
>
>     Bo Xu wrote:
>     > Hi,
>     >
>     > if I have a endpoint whose IP is 10.1.11.116, but it is not registered to
>     > my GnuGK, in this case, can I set the gatekeeper.ini so GnuGK can "map"
>     > that endpoint's IP(10.1.11.116) to an "number"(for example 8000), then
>     > later on when I want to call that endpoint I will call GnuGK like
>     > "GnuGKIP##8000"?
>     >
>     > can I do the above with GnuGK? or I must register that endpoint to GnuGK
>     > then after that I can call it with "GnuGKIP##Alias"? Thanks!
>     >
>     > Regards,
>     > Bo Xu
>
> ------------------------------------------------------------------------------
> What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
> patterns at an interface-level. Reveals which users, apps, and protocols are
> consuming the most bandwidth. Provides multi-vendor support for NetFlow,
> J-Flow, sFlow and other flows. Make informed decisions using capacity
> planning reports. http://sdm.link/zohodev2dev
>
> _______________________________________________________
>
> Posting: mailto:[email protected]
> Archive: http://sourceforge.net/mailarchive/forum.php?forum_name=openh323gk-users
> Unsubscribe: http://lists.sourceforge.net/lists/listinfo/openh323gk-users
> Homepage: http://www.gnugk.org/

------------------------------------------------------------------------------

_______________________________________________________

Posting: mailto:[email protected]
Archive: http://sourceforge.net/mailarchive/forum.php?forum_name=openh323gk-users
Unsubscribe: http://lists.sourceforge.net/lists/listinfo/openh323gk-users
Homepage: http://www.gnugk.org/