Re: Get channel variables via ARI/AMI

>> There are SOME protocol level things accessible using CHANNEL[1] but that's it.

>> [1] https://wiki.asterisk.org/wiki/display/AST/Asterisk+20+Function_CHANNEL

 

 

I am trying to use the CHANNEL function listed above from the AMI.  Since it is not an AMI “action”, but rather a dialplan “function”, I’m trying to figure out how to call this from the AMI.  Using a telnet session to the AMI I’ve tried variations of:

 

action: command

actionid: id123

command: channel(PJSIP/240000-1a)

 

but they don’t work.  Is the basic concept correct that I can using the “command” action to run a statement that would work in the dialplan?  If not, how would I call “channel” from the AMI ?

 

Thanks

Brian

-- 
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --

Check out the new Asterisk community forum at: https://community.asterisk.org/

New to Asterisk? Start here:
      https://wiki.asterisk.org/wiki/display/AST/Getting+Started

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users