Re: AMI versions

I’m trying coresettings through the AMI but getting a permission denied error.  I think I’ve added all permissions:

 

read=system,call,log,verbose,command,agent,user,config,dtmf,reporting,cdr,dialplan,originate

write=system,call,log,verbose,command,agent,user,config,dtmf,reporting,cdr,dialplan,originate

 

Where can I find the permission needed for this command?

 

From: asterisk-users [mailto:[email protected]] On Behalf Of Joshua C. Colp
Sent: Tuesday, July 11, 2023 2:43 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion <[email protected]>
Subject: Re: [asterisk-users] AMI versions

 

On Tue, Jul 11, 2023 at 3:40 PM Joshua C. Colp <[email protected] <mailto:[email protected]> > wrote:

On Tue, Jul 11, 2023 at 3:38 PM TTT <[email protected] <mailto:[email protected]> > wrote:

That answers part two…but is there any mapping of AMI version to Asterisk versions?

 

No, there is not.

 

I can say that Asterisk 13 is 2.x.x though because I just looked, so you can use the version policy to determine what each release is subsequently.

 

-- 

Joshua C. Colp

Asterisk Project Lead

Sangoma Technologies

Check us out at www.sangoma.com <http://www.sangoma.com>  and www.asterisk.org <http://www.asterisk.org>

-- 
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --

Check out the new Asterisk community forum at: https://community.asterisk.org/

New to Asterisk? Start here:
      https://wiki.asterisk.org/wiki/display/AST/Getting+Started

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users