Re: Problem with PSTricks using MikTex 2.9

Are you compiling to dvi or pdf?

On Mon, Oct 31, 2016 at 11:03 PM, Bruce Allison <[email protected]>
wrote:

> I am trying without success to draw a diagram using the latex package
> PSTricks.  A minimal version of the the command sequence that I am using
> is:
>
> \documentclass{article}
> \usepackage{pstricks}
> \begin{document}
> \begin{pspicture}(-1,-1)(5,2)
> \psline(0,0)(4,0)
> \psline(2,0)(2,1)
> \end{pspicture}
> \end{document}
>
> When I try to compile these commands using latex  in MikTex 2.9 (under
> WinEit 6), I get the message:
>         "MikTex Problem Report.  Some PostScript specials could not be
> rendered."
>
> Exactly the same commands compile without any problem using PCTex 6
> instead of MikTex 2.9 (but unfortunately PCTex 6 will not work for my
> whole project).
>
> I have uninstalled and then reinstalled MikTex (under Windows 10) but
> this doesn't help.
>
> I really need to draw a lot of similar pictures  in an article, and I
> have hit a wall here.  Any suggestions about how to avoid this PSTricks
> problem using Miktex will be greatly appreciated!
>
> Bruce
>
>
>
>
>
> ------------------------------------------------------------
> ------------------
> Developer Access Program for Intel Xeon Phi Processors
> Access to Intel Xeon Phi processor-based developer platforms.
> With one year of Intel Parallel Studio XE.
> Training and support from Colfax.
> Order your platform today. http://sdm.link/xeonphi
> _______________________________________________
> Q: How can I leave the mailing list?
> A: See http://docs.miktex.org/faq/support.html#leavingml
>
------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today. http://sdm.link/xeonphi
_______________________________________________
Q: How can I leave the mailing list?
A: See http://docs.miktex.org/faq/support.html#leavingml