Re: tetex-3.0: problem with times at 10pt?

I will send you a copy of a PDF version in private email in a minute or
so. However, you didn't say what version of Acrobat you used. It might
help to upgrade to a newer version. Also, some HP printers have two
alternative printer drivers, one using Postscript and one using PCL.
I have experienced that it may help to switch to the other driver
occassionally.

    /Mats

Ondrej Drbohlav wrote:
> Hi, 
> 
> I am having problems with the document below. When I compile it with 
> pdflatex, the PDF looks OK in AcrobatReader but it prints badly at several 
> HP laser printers (the font is right, but vertical letter positioning is broken)
> 
> To find out whether this is a tetex-3.0 bug or just a bug in my installation, 
> may I kindly ask someone who has tetex-3.0 installed to compile the source by 
> pdflatex and provide me with the PDF?
> I will then try to print it out on the same printers and let this archive list 
> know the result. 
> 
> Cheers, 
> 
> Ondrej
> 
> %%%%%%%%%%%%%%%% begin source
> \documentclass[10pt]{article}
> \usepackage{times}
> \begin{document}
> Problem with uniform intensity. The input
> data are not funny either.
> 
> Watch the words {\em uniform} and {\em input data are} above.
> \end{document}
> %%%%%%%%%%%%%%%%% end source
> 
> 
> 
> 

-- 
=============================================
	Mats Bengtsson
	Signal Processing
	Signals, Sensors and Systems
	Royal Institute of Technology
	SE-100 44  STOCKHOLM
	Sweden
	Phone: (+46) 8 790 8463				
         Fax:   (+46) 8 790 7260
	Email: [email protected]
	WWW: http://www.s3.kth.se/~mabe
=============================================