Re: Unreferenced Node

Heime via Users list for the Texinfo documentation system <[email protected]> Sun, 18 May 2025 12:26:11 +0000

Newsgroups	gmane.comp.tex.texinfo.general
Message-ID	<9hmPHncSyTaU2wAGwsVDQ5Uz7qWA-hPfNgXoRbCeS50oIB6jk4gfOryx91C4aYCdBaLvkD3WxXsliyt7_yCXZK9wAq9OXesyiBzZCN--aXQ=@protonmail.com>





Sent with Proton Mail secure email.

On Sunday, May 18th, 2025 at 4:33 PM, Eli Zaretskii <[email protected]> wrote:

> > Date: Sat, 17 May 2025 19:18:18 +0000
> > From: Heime [email protected]
> > Cc: [email protected]
> > 
> > > > How would I make the menus for the document, how would it be for this case?
> > > 
> > > You already have a menu. Just add there all of the nodes in the
> > > document.
> > 
> > Is that for all sectionings (chapter, section, subsection, subsubsection, ...)?
> 
> 
> Yes, but preserving the hierarchy: subsection nodes should appear in
> menus in section nodes, etc.
> 
> > What is the following about, where instead of "::" one uses a single ":"?
> 
> 
> This is described in the Texinfo manual. 

Where in the textinfo manual?

> The text after the colon is
> the name of the node, but if it's the same as the menu item, you can
> use "::". That is, "Files::" stands for "Files: Files."

I am using sections, subsection, etc and getting 

icord.texi:151: raising the section level of @subsection which is too low

What is the problem, and how should the menu be written for sections and
subsections?