Re: figure problem
Harish Kumar Holla <[email protected]>
| Newsgroups | gmane.comp.tex.tugindia |
|---|---|
| Message-ID | <[email protected]> |
\begin{figure}[h] = Put the figure *HERE* (where you are writing
\begin{figure}, and LaTeX has some freedom to adjust depending upon the page
structure. [h!] means put the figure *HERE* without worring about anything
else and you are asking LaTeX not to adjust.
Similarly [t] = top of the page, [b] = bottom of the figure and [p] = in a
new page containing only floats. Hope this is clear.
On Thu, Jun 30, 2011 at 1:58 AM, jaspreet kaur <[email protected]>wrote:
> hello
> can anybody tell me what is the meaning of 'h'
> in the following command
> \begin{figure}[h]
> Also [h!]
> And what is the difference between [h] and [h!]
> _______________________________________________
> Home: http://www.tug.org.in/
> TeX FAQ: http://www.tex.ac.uk/faq
> unsubscribe: http://tug.org/mailman/listinfo/tugindia
>
--
--with regards
Dr. Harish Kumar
Dept. of Physics
Pondicherry Engineering College
Puducherry 605 014
Ph: 0413 2655281-286 (Extn: 646)
Residence:
Dr. Harish Kumar
# 29 (New No.) I Main Cluny Road
Avvai Nagar, Lawspet
Puducherry 605 008
Ph: 0413 2253652, 9443052957
_______________________________________________
Home: http://www.tug.org.in/
TeX FAQ: http://www.tex.ac.uk/faq
unsubscribe: http://tug.org/mailman/listinfo/tugindia