Re: How to disable rate limiting

Thanks for the clarification! Re-reading the man page, I now realize=20
that the phrasing "[t]his directive enables rate limiting" indeed=20
implies that it is disabled when this directive is not set (regardless=20
of further directive options).

I also found that the "noclientlog" directive did not directly match the=
=20
desire to "disable" (unnecessarily, as I now know) the rate limiting.=20
But as I anyhow use the functionality of the "noclientlog" directive on=20
my pool servers for performance reasons, I didn't mind too much that it=20
wasn't a "clean" solution to disabling the rate limiting. But still=20
happy to see the latter is taken care of in a more dedicated fashion=20
already.

Kind regards,

Joachim

On 01.09.25 08:35, Miroslav Lichvar wrote:
> On Fri, Aug 29, 2025 at 01:31:21PM +0200, Ji=C5=99=C3=AD =C4=8Cin=C4=8Du=
ra wrote:
>> How can I completely disable rate limiting? If I omit `ratelimit` will =
it use default setting or is the rate limiting going to be disabled? I can=
 use `interval -19`, but that's more like a workaround than solution.
>=20
> Rate limiting is disabled by default. The default settings mentioned
> in the man page apply when "ratelimit" is added to the config without
> any options.
>=20


-- 
To unsubscribe email chrony-users-request-kWFZVVI9zxvPqho9SqqRMmD2FQJk+8+b@public.gmane.org 
with "unsubscribe" in the subject.
For help email chrony-users-request-kWFZVVI9zxvPqho9SqqRMmD2FQJk+8+b@public.gmane.org 
with "help" in the subject.
Trouble?  Email [email protected]