Re: Remove channel from XMLTV file
Karl Dietz <[email protected]>
| Newsgroups | gmane.comp.tv.xmltv.general |
|---|---|
| Message-ID | <[email protected]> |
On 09.10.2014 12:03, [email protected] wrote: > On Wed, 8 Oct 2014 21:56:05 +0200, Josu Lazkano wrote: > >> Hello, >> >> I have a little problem with a XMLTV file. >> >> I use to grab the channels information with a mhw program. But there >> is a channel with this name: >> >> [line 96]<channel id="dgplus31.sp"> >> [line 97]<display-name>A&E</display-name> >> [line 98]</channel> >> >> If I open this file with Chrome web browser, it says: error on line 97 >> at column 18: EntityRef: expecting ';' > > Your "mhw program" (whatever that is) is faulty. Ampersand is a special character in XML and must be converted to the format "&" Given that a report of the same problem against our tv_grab_eu_epgdata was reported earlier that day it might be that mhw (whatever that is) is the consumer of the data and confused by the wrong encoding of the ampersand by the xmltv grabber, see http://sourceforge.net/p/xmltv/mailman/message/32908363/ Regards, Karl ------------------------------------------------------------------------------ Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk