Re: Transition from tv_grab_uk_rt to tv_grab_sd_json

On Sun, Jun 5, 2016 at 5:23 AM, Geoff Clare <[email protected]>
wrote:

> * Programme timings were all one hour early.  I suspect this is because
>

In the General Setup in the MythTV backend setup there is an XMLTV Offset
setting.  Have you tried setting this to Auto?


> (Since I'm on MythTV 0.24 I also put
> back the $previously_shown{'start'} = $dt->strftime('%Y%m%d%H%M%S %z');
> line that was changed to '%Y%m%d' in XMLTV 0.5.68.)
>

I have been planning on adding a config option to specify the previously
shown date format to address this but have not gotten to it yet.


> * Some of my test runs reported "Use of uninitialized value in sprintf" for
> the line: $ch{'id'} = sprintf($channel_id_format, $channel->{'stationID'});
> in write_channel.
>

I just tried a couple tests using the GBR-0001314-DEFAULT lineup but did
not experience the same warning.  If it happens again maybe you can post
some more details or try to narrow down a test case to trigger it.


Kevin

------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e

_______________________________________________
xmltv-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xmltv-users