Re: Transition from tv_grab_uk_rt to tv_grab_sd_json

On Sun, Jun 5, 2016 at 5:23 AM, Geoff Clare <[email protected]>
wrote:

> * Some of my test runs reported "Use of uninitialized value in sprintf" for
> the line: $ch{'id'} = sprintf($channel_id_format, $channel->{'stationID'});
> in write_channel. It didn't happen in last night's run from cron and things
> seem to be working, so I have ignored it, but the developers might want to
> look into it.
>

I have found that if the config file contains a channel that is not in one
of your enabled lineups then this error can occur. This could happen if the
config was edited manually with an invalid entry or the channel was removed
from the lineup by SD. I have committed a fix which gives a more helpful
message in this case and prevents the invalid channel data from being in
the XML output.  Hopefully this address your issue.

Kevin

------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e

_______________________________________________
xmltv-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xmltv-users