Re: Generic language listings

On 07/13/13 23:33, Jeff Kingston wrote:
> Dear [email protected],
Hello,

Thank you for your general support and replies. My master opus was done 
primary with the Lout (except the front and a second page, it was done 
with another tool and glued with a PDF utility).
>
>> There are extremely important spaces (I would like to use some
>> gray dot distinguished from the typical dot in a source code),
>> new-lines, and would be great to have a rule with the lines-of-code.
> You seem to be suggesting that someone else should make this happen
> for you.  If that's your plan, it's doomed to disappointment.  You
> need to become enough of an expert to make it happen yourself.
>
>> Unfortunately there is still a problem with a character width.
> Post a very small example of a Lout source file, with the
> corresponding PostScript file showing the problem.
I can't post you a piece of my work (as I'm not an owner of it anymore) 
neither I was able to reproduce it with a dummy example. So, please let 
me just to notify you that super-signed characters (at least Polish) 
with random and unreproducible situations the fonts of headers, titles 
(lin general a larger text) seemed to have "resetted properties" -- it 
looked as they would be too narrow, and so overlapping, ad their width 
was the same as a standard character in a text field.

The second problem that I ran into was with multipage tables. I had 
found a documented bug against it, that produces a shifted table; the 
mentioned walka-round worked, however there was another bug that with a 
certain situation a page break resulted with a rotated (A4) pages and 
general mess until the end of the table and a page after the end of it. 
I was trying to resolve it within 2-3 days (examining each character 10 
times, trying to break table into multiple tables one each page etc) , 
and finally reedited it into nested lists....
>
>> @F @Verbatim works very bad here, it cuts the white-space (most
>> notably at the beginning of the file and line - and this produces
>> incorrect source code).
> Then RTM and try @F @RawVerbatim.
Yes, this was what I was looking for and it helped me out, to spot the 
solution. It's valuable to say of @RawVerbatim over the manual in the 
relevant section as well.
>
>> Is possible to rename @Floater into "Code listing"
> RTM, Section 2.13.
I haven't found this part that obvious and as a walk-around (sorry, my 
time was that month too short), I reedited the library definitions.
>
> Jeff
>
I can't work out the posted problems, trying to reproduce and help to 
debug it, as I'm needed on the other side of the open-source planet; 
once again thank you very much against your great piece of software!

With kind regards,


PS. It's worth mentioning in the RED that "//" is NOT a comment. I'm 
still stuned with the fact, that my C, C++ brain made as completely 
transparent as a comment in a source-code, and it pushed me to search 
the problem on all the different fields.