Apply global setting to single command?

I want the -q global setting to be applied to the update command, but
no other commands.  I don't care about the list of directories that
gets shown by the update command, but I don't want to make any other
commands quiet.  Is this possible in WinCVS?  At the moment I have
WinCVS 2.0.9.1 (Build 1) installed.

Note that I already created a .cvsrc file in my CVS home with the -d
option specified for update, but -q is a global CVS option, and the
cvsnt documentation didn't provide any way of setting global settings
for a single sub-command.  (Am I correct that there's no way inside
the WinCVS GUI to have sticky settings for the individual commands?  I
certainly couldn't see a way to make it happen.)

Sorry if this has been asked before (or even asked many times), but
it's kind of hard to do good searches on such a large archive.  I did
at least try.

--Travis Cobbs



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Yahoo! Groups gets a make over. See the new email design.
http://us.click.yahoo.com/hOt0.A/lOaOAA/yQLSAA/z3wwlB/TM
--------------------------------------------------------------------~-> 

 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cvsgui/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/cvsgui/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/