Re: wrong repository on update

mikekay8888 wrote:
> Greetings all.  I have wincvs partially working - I can upload a
> complete repository fine, the connection works and the upload works,
> but when I try to run the update command I get a message that says
> /test: no such repository - which is correct - there is no test
> repository, but where can I change this setting to the proper
> repository?
> 

Sorry, I don't completely understand your setup.  What version of WinCvs 
are you using?  When you say you "upload a complete repository", what do 
you mean by that?  Did you run the import command?  If so, you had to 
tell it what your target repository was, via CVSROOT specification. 
I've never had occasion to do that, but I'm guessing you would then have 
to check out that remote repository into a new local sandbox, which you 
could then update.

-- 
Guy Rouillier


------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cvsgui/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/cvsgui/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/