Re: New branch name with no other changes

On Fri, Jun 10, 2011 at 04:40:59PM +0200, Thomas Keller wrote:
> Am 10.06.2011 16:26, schrieb Hendrik Boom:
> > Actually, the approve command worked fine, though it took a few moments 
> > to determine the right revision ID.  Maybe approving the revision in the 
> > current workspace should be an option on that command?  I wouldn't want 
> > it to be the default: too easy to approve the wrong thing by accident.
> 
> You could use
> 
> 	mtn approve -b new.branch w:
> 
> for the very same purpose and don't have to figure out the current rev
> id at all.

That wasn't obvious from the documentation of the mtn approve command.
Presumably w: is a form of revision-id, which I'm sure is documented 
somewhere else where I didn't happen to look.

-- hendrik