For your project, take a cube, extrude it downwards while holding Cntrl Key
down. Move it down one. Hit enter, repeat process till you have a rectangle
with about 5 sections, or ever how many primary colors there are. You will need
this when you imitate the light diffracting as it hits prism.
Make sure you are at frame 1.Type I key to insert the rectangles loc,size
position,blah,blah. Advance animation frame counter to 25,then take all the
vertices on one edge of the rectangle, and extrude them to where the prism will be
located. Hit I key again. To see what it will look like, just click on frame
key, will show the rectangle slowing extruding. Bah, since its for a school,
will send you direction,with a couple of screen shots
[Non-text portions of this message have been removed]
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.