Re: Re: palne is exturding in both direction

Sorry for late replying but finally got it working :)
thank u very much for ur help Dmeinkboy & *Rich Gautier :)*

On 10/19/06, [email protected] <[email protected]> wrote:
>
>   For your project, take a cube, extrude it downwards while holding Cntrl
> Key
> down. Move it down one. Hit enter, repeat process till you have a
> rectangle
> with about 5 sections, or ever how many primary colors there are. You will
> need
> this when you imitate the light diffracting as it hits prism.
> Make sure you are at frame 1.Type I key to insert the rectangles loc,size
> position,blah,blah. Advance animation frame counter to 25,then take all
> the
> vertices on one edge of the rectangle, and extrude them to where the prism
> will be
> located. Hit I key again. To see what it will look like, just click on
> frame
> key, will show the rectangle slowing extruding. Bah, since its for a
> school,
> will send you direction,with a couple of screen shots
>
> [Non-text portions of this message have been removed]
>
>  
>



-- 
There is no point in knocking the "closed Windows" when the door is "Open".
Open your eyes, use open source software.

PLEASE VISIT & REGISTER @ "www.ossrc.org.in"

Regards,
Yogesh


[Non-text portions of this message have been removed]