Re: Compiling CinePaint from source
Kai-Uwe Behrmann <[email protected]>
| Newsgroups | gmane.comp.video.cinepaint.devel |
|---|---|
| Message-ID | <[email protected]> |
Hello Mohanjith, good, you posted the output. Am 20.02.08, 04:17 +0530 schrieb Sudirikku Mohanjith: > [moha@localhost cinepaint-0.22-1]$ ./configure --enable-gtk2 and > --enable-pygimp --host=i386-redhat-linux That line should be ./configure --enable-gtk2 --enable-pygimp If you use the --host=i386-redhat-linux option is up to you. The "and" came probably from my email. Sorry. > configure: WARNING: you should use --build, --host, --target > checking for a BSD-compatible install... /usr/bin/install -c ... > checking build system type... Invalid configuration `and': machine > `and' not recognized > configure: error: /bin/sh ./config.sub and failed > On Feb 19, 2008 2:43 AM, Kai-Uwe Behrmann <[email protected]> wrote: > > Am 19.02.08, 02:24 +0530 schrieb Sudirikku Mohanjith: > > You'd need the --enable-gtk2 and --enable-pygimp configure flags to build > > rpm's. kind regards Kai-Uwe Behrmann -- developing for colour management www.behrmann.name + www.oyranos.org ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/