Re: Os X Intel build of cinepaint

On Mar 2, 2008, at 8:06 AM, Thomas Huffman wrote:

> 3) build glib
> 	- copy config.guess and config.sub from cinepaint-0.22-1 folder  
> into glib.
> 	- edit gstrfuncs.c.  There are four instances of  
> G_GNUC_PRETTY_FUNCTION, add a comma(,) after each.
> 	- run configure as './configure --prefix=/sw'
> 	- run make; make install
>

Hi Tom,

I didn't find glib-1.2.10, instead I grabbed 2.14, which could have  
caused the following error when I followed your instructions:

1) I didn't find G_GNUC_PRETTY_FUNCTION in gstrfuncs.c .  Could this  
be due to using a later version of glib I wonder.
2) I went ahead with configure anyway, and it complained that first I  
needed gettext, so I built that first.   All this done in /sw.  I'm  
using --prefix=/sw per your recommendation and also because having  
used macports already, I have libs in /opt/local, and don't want them  
to conflict with these builds.
3) then the configure for glib failed with this error:
*** You must have either have gettext support in your C library, or  
use the
*** GNU gettext library. (http://www.gnu.org/software/gettext/gettext.html 
)

If you think I need glib-1.2.10 instead of 2.14, and know where to  
find it, that may be the problem here.

thanks very much for your help.
Rob

--
Rob Lingelbach
[email protected]  http://www.colorist.org/robhome.html




-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/