[PATCH v2] drm/bridge: ti-sn65dsi83: Cancel reset_work on remove to avoid use-after-free

The error recovery code queues reset_work from the threaded IRQ handler
and polling monitor_work. Neither the remove path nor the probe failure
path after the IRQ is registered drains that work before devres releases
the bridge allocation.

Use drm_bridge_unplug() before stopping the work. It prevents a concurrent
atomic commit from entering the bridge and re-arming monitor_work through
monitor_start(), and waits for in-flight bridge critical sections to
finish. Then disable the IRQ and drain monitor_work and reset_work.

Use the same shutdown sequence when attaching the DSI host fails. This
prevents error recovery work queued by an early IRQ from accessing the
devm-managed bridge after the failed probe returns.

This issue was found by an in-house static analysis tool.
Compile-tested only; runtime testing is appreciated.

Fixes: ad5c6ecef27e ("drm: bridge: ti-sn65dsi83: Add error recovery mechanism")
Cc: [email protected]
Assisted-by: Codex:gpt-5.6
Signed-off-by: Fan Wu <[email protected]>
---
Changes since v1:
  - Move drm_bridge_unplug() ahead of the work cancellation so a concurrent
    atomic commit cannot re-arm monitor_work via monitor_start() after the
    cancel.
  - Drain from the probe-error path (err_remove_bridge) too, closing a UAF
    where a spurious IRQ during probe queues reset_work and a later
    -EPROBE_DEFER frees ctx.
  - Factor the sequence into sn65dsi83_stop_error_recovery() shared by
    both paths.

 drivers/gpu/drm/bridge/ti-sn65dsi83.c | 14 ++++++++++++--
 1 file changed, 12 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi83.c b/drivers/gpu/drm/bridge/ti-sn65dsi83.c
index 42b451432bbb..5f1a96856eac 100644
--- a/drivers/gpu/drm/bridge/ti-sn65dsi83.c
+++ b/drivers/gpu/drm/bridge/ti-sn65dsi83.c
@@ -997,6 +997,18 @@ static irqreturn_t sn65dsi83_irq(int irq, void *data)
 	return IRQ_HANDLED;
 }
 
+static void sn65dsi83_stop_error_recovery(struct sn65dsi83 *ctx)
+{
+	/* Block new bridge users and wait for existing critical sections. */
+	drm_bridge_unplug(&ctx->bridge);
+
+	if (ctx->irq)
+		disable_irq(ctx->irq);
+
+	cancel_delayed_work_sync(&ctx->monitor_work);
+	cancel_work_sync(&ctx->reset_work);
+}
+
 static int sn65dsi83_probe(struct i2c_client *client)
 {
 	const struct i2c_device_id *id = i2c_client_get_device_id(client);
@@ -1061,7 +1073,7 @@ static int sn65dsi83_probe(struct i2c_client *client)
 	return 0;
 
 err_remove_bridge:
-	drm_bridge_remove(&ctx->bridge);
+	sn65dsi83_stop_error_recovery(ctx);
 	return ret;
 }
 
@@ -1069,6 +1081,6 @@ static void sn65dsi83_remove(struct i2c_client *client)
 {
 	struct sn65dsi83 *ctx = i2c_get_clientdata(client);
 
-	drm_bridge_unplug(&ctx->bridge);
+	sn65dsi83_stop_error_recovery(ctx);
 }
 
-- 
2.51.0