mach64 complaining about wrong version in drm-module

Just for completion the output of lspci -vvv
Since the card is not recognized by drm

01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage LT Pro
AGP-133 (rev dc) (prog-if 00 [VGA])
    Subsystem: CLEVO/KAPOK Computer Unknown device 3102
    Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
    Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
    Latency: 0 (2000ns min)
    Interrupt: pin A routed to IRQ 10
    Region 0: Memory at d8000000 (32-bit, non-prefetchable) [size=16M]
    Region 1: I/O ports at 8000 [size=256]
    Region 2: Memory at d9000000 (32-bit, non-prefetchable) [size=4K]
    Expansion ROM at d0000000 [disabled] [size=128K]
    Capabilities: [50] AGP version 1.0
        Status: RQ=256 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans-
64bit- FW- AGP3- Rate=x1,x2
        Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=<none>
    Capabilities: [5c] Power Management version 1
        Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
        Status: D0 PME-Enable- DSel=0 DScale=0 PME-

-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/

--
_______________________________________________
Dri-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/dri-users