Re: TvOut on ATI Rage TvOut on Ati Rage Mobility P/M

Thanks for clearing this up. Is the way the atitvout too (which is GPL by
the way) enables / disables connections, with vbe calls I believe,  on this
mach64 card really that different from how a radeon driver does it ? Anyway
I am just curious and I don't know a lot about this.

Thanks for your reply,
Edwin

On Dec 16, 2007 1:35 AM, Alex Deucher <[email protected]> wrote:

> On Dec 14, 2007 5:17 PM, Edwin de Caluwé <[email protected]> wrote:
> > I am not sure if this is an appropriate place to ask, but I hope so.
> >
> > On an old machine of mine I recently tried to enable Tv Out.
> >
> > The graphics cars is an Ati Rage Mobility P/M (Mach 64).
> >
> > The dri wiki
> > (http://dri.freedesktop.org/wiki/ATI)
> > mentions that the old GATOS project for tv out is incorporated into the
> > X.org drivers. A long time ago I had once used this same GATOS to get
> the TV
> > out working in linux.
> >
> > http://www.x.org/wiki/radeonTV
> > Describes that the minimum driver version required is 6.7.191. I am
> running
> > 6.7.195 shipped with Ubuntu 7.10. This should be sufficient.
> >
> > Futhermore randr 1.2 is required. This is also the version I am running.
> >
> > I tried to enable tvout using xrandr. However xrandr does not recognize
> the
> > attached S-video connector. According to the wiki this should work but
> it
> > does not.
> >
> > I managed to work around this with the (very old) atitvout utility to
> > enable/disable lcd,crt and tv connections. This works, however even when
> tv
> > out is enabled using atitvout, randr still does not recognize the
> > connection.
> >
> > Is this a known problem in randr + x.org driver? How can i get tv out
> and
> > secondary display working with randr ?
>
> The Rage Mobility P/M is mach64 based.  Only the radeon driver has
> xrandr 1.2 support.  The "ati" driver is actually just a wrapper that
> loads the appropriate real driver depending on what card is detected:
> ati_misc, r128, or radeon.  GATOS only supported TV-out on radeon chip
> as well.  for your chip you can try the following options to enable
> tv-out, but YMMV.
> Option "tv_out" "true"
> Option "tv_standard" "NTSC" or "PAL", etc.
>
> Alex
>

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace

--
_______________________________________________
Dri-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/dri-users