Re: Re: gnu m4 configure

Howard Larson wrote:

> Good question.  I am only doing it because autoconf configure 
> complained it couldn't find m4.  I am beginning to think I am going 
> round in circles.  I was able to get hugin build capability up and 
> running in a fraction of the time spent on this so far.  And, all I set 
> out to do was build a plugin.  Comical, isn't it?

IIRC your goal is to improve print support on Windows. In order to do 
this for SVN Trunk, you should rather have a look at the printing code 
in GTK+.



HTH,
Michael

-- 
     GIMP > http://www.gimp.org      | IRC: irc://irc.gimp.org/gimp
     Wiki > http://wiki.gimp.org     | .de: http://gimpforum.de
Plug-ins > http://registry.gimp.org |

------------------------------------

List archives: <http://groups.yahoo.com/group/gimpwin-users/>
To unsubscribe send a blank message from the address you're subscribed
to <mailto:gimpwin-users-unsubscribe-hHKSG33TihhbjbujkaE4pw@public.gmane.org>Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/gimpwin-users/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/gimpwin-users/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:gimpwin-users-fullfeatured-hHKSG33TihhbjbujkaE4pw@public.gmane.org

<*> To unsubscribe from this group, send an email to:
    gimpwin-users-unsubscribe-hHKSG33TihhbjbujkaE4pw@public.gmane.org

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/