Re: perlmagick try catch

Thanks Bob, and your answer was useful. May I post it for all to see?

On Fri, Jul 24, 2015 at 12:43 PM, Bob Friesenhahn <
[email protected]> wrote:

> On Fri, 24 Jul 2015, Rick Leir wrote:
>
> > Hi Bob and everyone,
> > (I am resending this because the lists were down)
> > Is there a way to catch exceptions? Here is a simple test, with an
> obvious error, Rotate does not accept geometry, but the program
> > does not get to the catch:
>
> I did previously respond directly to your email address.
>
> To my knowledge, the GraphicsMagick variant of PerlMagick does not
> throw native Perl exceptions.  Instead it returns a parsable string
> which includes the word "Exception".
>
> Perhaps PerlMagick was implemented before Perl supported exceptions.
>
> Bob
> --
> Bob Friesenhahn
> [email protected], http://www.simplesystems.org/users/bfriesen/
> GraphicsMagick Maintainer,    http://www.GraphicsMagick.org/
>
>
> ------------------------------------------------------------------------------
> _______________________________________________
> Graphicsmagick-help mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/graphicsmagick-help
>



-- 
Rick Leir
Developer, Canadiana.ca

------------------------------------------------------------------------------

_______________________________________________
Graphicsmagick-help mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/graphicsmagick-help