Re: [graphviz-interest] dotty putting everything on one line

> I've created a dotty-file ahttp://keetweej.vanheusden.com/inbox.dot
> Now when I render it to svg (or png, whatever), it puts every cluster
> to the right of the other. So all clusters are on one line:
> http://keetweej.vanheusden.com/inbox4.svg
> Is it possible to instruct dotty to spread the clusters over the page?
> Because I now often get an error of either the program displaying it
> that it is too large to display or dotty simply segfaulting.

What I would like is that ratio="auto" without size set would create a
square where it fits everything in, expanding the square where needed,
preferably with no initial size set.

Tried setting the page-size but then it doesn't move the clusters, it
only makes them smaller (unreadable).


Folkert van Heusden

-- 
MultiTail na wan makriki wrokosani fu tan luku den logfile nanga san
den commando spiti puru. Piki puru spesrutu sani, wroko nanga difrenti
kroru, tya kon makandra, nanga wan lo moro.
http://www.vanheusden.com/multitail/
----------------------------------------------------------------------
Phone: +31-6-41278122, PGP-key: 1F28D8AE, www.vanheusden.com
_______________________________________________
[email protected]
http://lists.research.att.com/mailman/listinfo/graphviz-interest