Re: identity/convert fig.ps is not returning the correct value

Jesus... thanks again. The pnmraw helped a lot.

However, I still have one problem more:

> montage -page A4 -geometry fig.ps fig.png

Then fig.png will show 3 pages, but not horizontally aligned as if my
input were fig.pdf.

If I don't put -page than my fig.png shows page 2 and 3 trimmed.

Many thanks in advance.
Alan

On Fri, Jul 18, 2008 at 2:07 PM,
<[email protected]> wrote:
>> And, of course, thousands of apologies if it's not an imagemagick
>> issue
>
> Its not, its an issue with DSC comments being wrong and ImageMagick
> making decisions about which Ghostscript device to use based on the
> incorrect information.  Other than modifying your legacy application
> to generate proper DSC comments you can edit delegates.xml and change
> the pngalpha device to pnmraw.  However, if you do, ImageMagick will be
> unable to render transparent EPS image files.
>



-- 
Alan Wilter S. da Silva, D.Sc. - CCPN Research Associate
Department of Biochemistry, University of Cambridge.
80 Tennis Court Road, Cambridge CB2 1GA, UK.
>>http://www.bio.cam.ac.uk/~awd28<<