Re: Lost frames, or what else?
Andrea Giuliano <[email protected]> Thu, 06 May 2010 22:12:30 +0200
| Newsgroups | gmane.comp.video.kino.devel |
|---|---|
| Message-ID | <1273176750.7682.1.camel@debian> |
Unfortunately, my camera is not of that kind: it's a very basic miniDV camera, but was the cheapest 1 megapixel camera when I bought it. On Wed, 2010-05-05 at 17:12 -0500, Carl Karsten wrote: > On Wed, May 5, 2010 at 4:04 PM, Andrea Giuliano <[email protected]> wrote: > > Okay, the capture from the miniDV camera ran perfectly fine. I took a > > rough look at it and I couldn't see any jump. Also, and this is very > > important, the capture last approximately 60 minutes. The capture > > affected by the jumps were substantially shorter than the orginal 8mm > > tape: I can remember a capture of just 43 minutes, and I was not used to > > eject a tape which had still more than 15 minutes to record! > > > > So the Canopus ADVC 110 has some problem. The firewire card I used to > > capture from the camera is always the same, so I don't think I'm going > > to try a capture through the Canopus using a different firewire card. > > > > I guess this thread should be closed now: at present my problem doesn't > > seem a kino/dvgrab problem. > > > > What model dv camera? I have seen some that will take a composite > input and either record to tape or stream dv over firewire. basically > taking the place of the Canopus box. > > -- Andrea Giuliano <[email protected]> ------------------------------------------------------------------------------